Quick answer
If a boom lift stops or won't respond, take your hands off the controls, note any display code or alarm, and check the usual causes: emergency stop pressed in, foot switch not held, tilt alarm on a slope, too much weight in the platform, low fuel, or the ground controls set to the wrong station. Then call us on 0472 721 234.
Sha hired an articulating boom lift from us, an LGMG AR11J, and left a Google review. The machine was “really great”, and when some issues came up while using it, our team was patient and helped work through them. This page uses that job to set out what to do if a boom lift does something you don’t expect on site, and how to set the hire up so it is less likely to happen.

The machine
The LGMG AR11J is a diesel articulating boom lift with a 12.75 m working height and a 10.75 m platform height, and it is 1.85 m wide. An articulating boom bends in the middle, so it can reach up and over things a scissor lift can’t. Articulating vs telescopic boom lifts explains when each one fits.
If the machine stops or won’t do what you ask
- Stop and stay calm. Take your hands off the controls. Don’t force a function that won’t move.
- Look at the display and listen for an alarm. Note any light, code or message. That is the first thing we will ask for.
- Check the usual causes. On most boom lifts these are the emergency stop pressed in at the ground or platform controls, the foot switch not held down, a tilt alarm because the machine is on a slope, too much weight in the platform, low fuel, or the selector at the ground controls set to the wrong station.
- Call us on 0472 721 234. Tell us the machine, where you are, what it is doing and what the display shows. Most problems are sorted over the phone.
- Bring the platform down the normal way if you can. If you can’t, follow your site’s rescue plan and the emergency lowering steps shown in the manual on the machine. Our rescue planning guide explains the plan to have in place before work starts.
Setting the hire up so it goes smoothly
- Take the handover. When the machine arrives, have the operator run through the controls, the emergency stop, the ground controls and emergency lowering with us.
- Check the ground and the slope. A boom lift is set up on firm, level ground. See our ground conditions guide.
- Check the licence. A boom-type EWP can need a high risk work licence. See EWP licences in NSW.
- Keep our number on you. It is on the machine, and you can call it any time during the hire.
Planning a boom lift job?
Send the height you need to reach, how far out you need to go, what’s in the way, the ground and your dates. Ask for a quote or call 0472 721 234.