32ft Electric Scissor Lift Hire Haulotte Compact 12 in Sydney

Working height is 12 m and the platform floor rises to 10 m. Working height is the platform height plus about 2 m for a person standing on the platform, which is how hire sizes are normally stated.

It is 1.2 m wide and 2.49 m long when stowed. We look for at least 50 mm of clearance beyond the machine width at each opening. Measure the narrowest point of the whole route, not just the final doorway: gates, door frames, corridors, lift cars and the turn in from a corridor, which needs more room than a straight approach.

Stowed (travel) height is 2.39 m. Check headroom along the route: door heads, roller doors, ducts, sprinklers and ramps.

Rated platform capacity is 300 kg. People, tools and materials all count.

A scissor lift goes straight up; the extension deck, where fitted, slides out over the front only. To work over an awning, a roof edge or plant, look at articulating boom lifts, which go up and out.

It is built for firm, level, hard surfaces: concrete floors, sealed paving and slabs. It is not for grass, gravel, mud or uneven ground. Check the floor or ground can carry its weight (see below).

Outdoor use is limited: it can work outside only within the conditions in its manual (firm level ground, reduced wind and occupancy where stated), so we confirm those for your site before outdoor work. Electric power means no exhaust indoors, but electric power alone does not make a machine rated for outdoor use.

Gradeability of 23% is the steepest slope it can drive up while stowed. That is not permission to raise the platform on a slope: elevated work needs ground within the manufacturer's tilt limit, and the tilt alarm stops elevation beyond it.

It runs on batteries (24V — 340Ah (C20)). You need a standard power outlet near where it is parked, and it should be charged at the end of each day. Ask us if your site power is limited or temporary.

Runtime depends on how far it drives, how often it lifts, the load, temperature and battery age, so there is no fixed number of hours. Plan to charge it every night, and tell us if your work involves a lot of driving between work areas.

It weighs about 2,470 kg. Weight alone does not show whether a floor can take it: suspended slabs, mezzanines, pits, pavers and lift cars need their rating checked against the wheel or track loads in the manufacturer's data, by someone able to assess the structure.

Delivery is from our Berkshire Park depot. Delivery is quoted with the machine for your suburb, site access and hire dates. Customer pickup has not been approved for this machine, so plan on delivery.

For delivery, the truck needs a firm, clear area to unload close to the work, and someone on site to sign for the machine.

• $70 + GST ($77 inc GST) per day, for hires of 3 months or more

Transport is quoted separately for your suburb and site. A longer-term rate applies only when the hire runs for its minimum period; a shorter hire is quoted at the rate for its actual length.

No high risk work licence is needed for a scissor lift in NSW. Operators must still be trained and competent for this type of machine and familiarised with this model before use, and many sites ask for an industry card such as the EWPA Yellow Card plus their own induction. SafeWork NSW licence guidance.

The machine, your dates, the site suburb and anything that limits access: the narrowest opening, headroom, ground type and how high the work is. The team confirms availability for your dates and that the machine suits the site, then sends the quote with delivery. Nothing is booked until we confirm.

A hire can be extended. Call or email the team with your hire reference and the new finish date, and earlier is better because the machine may be committed to another job. Extra time is confirmed with you, and the rate for the longer period is confirmed with it: a change to the booking can mean the rate is revised, a minimum hire applies, or the correct rate for the actual hire period is used.

Hire charges run until the machine is properly off-hired with Equip Hire and is available for collection, clean, accessible and safe to collect. To off-hire you contact Equip Hire directly and get an off-hire number or confirmation back. Stopping work, leaving the machine on site, telling another contractor or assuming we know the job is finished does not end the hire. Charges stop at the confirmed off-hire, not on the day the truck happens to arrive, but they can continue if the machine is not accessible or ready when we come for it.

• Haulotte Compact 8N Narrow Electric Scissor Lift: narrower at 0.81 m, smaller, 9.8 m working height
• Skyjack SJIII 4740 Electric Scissor Lift: reaches higher, 13.8 m working height
• Skyjack SJIII 3226 Narrow Electric Scissor Lift: narrower at 0.81 m, smaller, 9.8 m working height