Equipment for sale
26ft Narrow Electric Scissor Lift for Sale
Zoomlion ZS0808AC
- IndoorsBest suited
- OutdoorsWorks here too, on firm level ground
26ft narrow electric scissor lift, 10 m working height indoors (7.8 m outdoors) and 230 kg on a 0.81 m wide chassis: for taller indoor and hard-surface work where the route is narrow. Measure the narrowest opening before booking.
Price on application
- Asset referenceEH-0808
We confirm this unit’s hours, condition and year when you ask.
Photos are our fleet photos of this model. Ask for current photos of this unit.
This unit is out on hire at the moment. Ask when it is next in our Berkshire Park yard to inspect.
Overview
About this machine
The specifications for this unit are below. Condition, hours and price are confirmed on enquiry, and you are welcome to inspect it at Berkshire Park.

Where it works
Best-fit jobs and sites
- Taller indoor work at racking height, warehouse and services maintenance, fit-outs needing more reach than a 19ft machine.
Good to confirm: Electric, hard-surface machine: firm level ground only. Outdoors it is rated to 7.8 m working height and 1 person (2 indoors); maximum working slope 1.5° side, 3° front to back (Zoomlion sheet). An online listing cannot replace a site assessment, so tell us the job and we will confirm suitability.
Decision panel
Will it suit this job?
Seven questions about this job, answered from this machine's verified specifications. All 17 figures are on file.
Reach
10 m
- Working height
- 10 mWhere your hands work with the operator standing on the platform. Size the machine on this figure.
- Platform height
- 8 mThe platform floor at full height, about 2 m below working height.
Access
0.81 m
- Machine width
- 0.81 mOnly a few centimetres narrower than a typical single door opening (about 0.82 m clear), so it must be measured. Many openings are less once the frame and hardware are counted. Measure the narrowest clear opening on the route, with room either side.
- Stowed height
- 2.40 m (rails up; 1.90 m rails folded)Check door headers, ducts and awnings on the route in.
- Length
- 2.49 mRoom to turn in corridors and lifts.
Surface
Indoor / hard standing
- Ground it suits
- Indoor / hard standingFirm, level ground: slab, sealed yard or compacted hardstand.
- Gradeability
- 25 %The steepest grade it may DRIVE on, stowed. Working on a slope is a separate, smaller limit in the manual.
- Outriggers
- NoStabilisers the machine sets down before it lifts, where fitted.
Load
230 kg
- Platform capacity
- 230 kg
- Deck extension
- 0.91m, 113kgRoll-out deck for reaching over an edge; its own lower rating applies.
Environment
Electric
- Power
- ElectricZero emissions and quiet: suits occupied buildings and after-hours work. Confirm the charging supply on site with us before delivery.
- Indoor / outdoor
- Indoor and outdoorAs rated by the manufacturer. Wind ratings still apply outdoors.
- Tyres
- Non-marking solidNon-marking: safe on finished floors.
Transport
2,090 kg
- Weight
- 2,090 kg
- Freight
- Quoted to your locationOr collect from our Western Sydney depot by arrangement.
Compliance
Scissor-type EWP. No high-risk work licence required in NSW; EWPA Yellow Card (SL) accepted competency.
- Competency
- Scissor-type EWP. No high-risk work licence required in NSW; EWPA Yellow Card (SL) accepted competency.No high-risk work licence applies to scissor or vertical lifts in NSW at any height. Site inductions still apply.
- Documents
- Manufacturer spec sheet on fileThe sheet governs every figure above.
A Confirm mark means the decisive figure is not on this record. Send us the site details and we will answer it before quoting; we never guess a specification.
Specifications
Full specifications
Grouped for quick scanning. A row appears once its figure is verified for this machine; anything not listed here is not yet on the record, and the Fit & access panel above marks it Confirm. The manufacturer spec sheet always takes precedence.
Reach & platform3 specs
- Working height
- 10 m
- Platform height
- 8 m
- Extension deck
- 0.91m, 113kg
Capacity1 spec
- Platform capacity
- 230 kg
Dimensions3 specs
- Overall length
- 2.49 m
- Machine width
- 0.81 m
- Stowed height
- 2.40 m (rails up; 1.90 m rails folded)
Performance4 specs
- Gradeability
- 25 %
- Terrain type
- Indoor / hard standing
- Indoor use
- Yes
- Outdoor use
- Yes, 1 person to 7.8 m outdoors (2 indoors), on firm, level hard standing. Best indoors.
Power & drive5 specs
- Power
- Electric
- Battery
- Electric
- Charging
- Onboard (240V outlet)
- Drive type
- 2WD
- Tyre type
- Non-marking solid
Machine & transport5 specs
- Manufacturer
- Zoomlion
- Model
- ZS0808AC
- Machine weight
- 2,090 kg
- Freight
- Quoted to your location
Dimensions at a glance
The numbers that decide access
- Machine width
- 0.81 m: only a few centimetres narrower than a typical single door opening (about 0.82 m clear); measure your narrowest clear opening, frame and hardware included
- Stowed height
- 2.4 m: check door headers, ducts and awnings on the route in
Drawn to scale from this machine's stored specifications. The manufacturer spec sheet (below) governs.
Condition and price
This machine
- Asset referenceEH-0808
Buying used? What to check before you buy · Handover and delivery checklist
Machines sell subject to prior sale. Condition, hours and price are confirmed on enquiry; no finance, warranty or delivery is included unless agreed in writing.
Send us your requirements and an Equip Hire equipment expert will contact you to confirm whether this machine is suitable for your application.
All machines for saleMore Zoomlion machines: see every Zoomlion machine on our range, or browse all the brands we hire.
Buying
Inspection, transport and handover
What happens between your enquiry and the machine arriving.
Swipe
Inspection
This unit is out on hire at the moment. When it is back at our Western Sydney depot you are welcome to inspect it, or have your own technician inspect it, before you commit. Ask us when it is next in the yard.
Transport
We sell Australia wide and can arrange transport to your state, or you are welcome to arrange your own carrier and collect from the depot.
Licence and competency
Scissor-type EWP. No high-risk work licence required in NSW; EWPA Yellow Card (SL) accepted competency.
What comes with it
Where we hold them, the machine is handed over with its specification sheet, operation manual and current plant registration. Ask us what exists for this unit before you buy.
Want to see it first?
Tell us where you are and what you need it for. We will confirm the condition, the hours and what transport to your state would involve.
Power
Charging this machine
Battery electric: charge it at the end of every shift.
Swipe
Charging supply
Onboard (240V outlet). Have that supply live near where the machine parks overnight.
Battery condition
Ask us for this unit’s battery age and condition and its charger details before you buy. We confirm them on enquiry.
Keeping it charged on site
- Confirm a live, accessible power point near where the machine parks overnight. A machine left away from power starts tomorrow flat.
- Plug in at the end of every shift, not “when it gets low”. Topping up at breaks helps on heavy days.
- Charge in a ventilated area and keep the charger and lead dry.
- Zero emissions and quiet running, so it suits indoor, occupied and after-hours work.
Safety
Pre-start checks, every day
Every Equip Hire machine is function-tested before it leaves the yard. The operator still checks it before each shift, tick these off as you go.
Swipe
Walk around
0/4Power on
0/3Function test
0/3Found a fault?
Tag it out and call us on 0472 721 234. Never operate a machine with a known fault, we will repair or swap it.
What counts as the record
Ticking here is a memory aid on your phone, nothing is stored. The machine’s own logbook and pre-start check sheet are the record. Based on the manufacturer’s daily check requirements and SafeWork NSW guidance for this kind of equipment.
Site prep
Before it arrives
Five minutes of checking here is what keeps a delivery from becoming a return trip.
Swipe
Measure the route, not the door
Every gate, corridor and lift on the way to the work area. Handles, hinges, bollards and stored materials all eat clearance.
Confirm the floor
A ground-bearing slab usually suits it. Suspended slabs, mezzanines and raised floors need the wheel loads checked against the floor rating.
Clear the work zone
Overhead services, sprinkler heads and light fittings at working height, and an exclusion zone for people below.
Make delivery space
Room for the truck to stop and unload safely. Tell us about docks, driveways and height limits when you book.
Find the power point
A live outlet near overnight parking so every day starts on a full charge.
Avoid
Mistakes we see weekly
The things that most often send a machine back or hold up a job.
Swipe
Booking on ceiling height
Measure to the actual task height, then choose the machine. Nothing added “just in case”.
Using the nominal door size
An 820 mm door leaf is not 820 mm of clear opening once the stop and hardware are counted. Measure the gap.
Assuming it can cross a bit of lawn
Wheeled machines rut turf and bog in soft ground. Say so when you book: a tracked machine may suit, after the ground is checked.
Leaving inductions to delivery morning
Shopping centres and managed sites need the paperwork approved before the truck arrives.
Documents
Manufacturer documents for this model. Swipe or scroll sideways to see them all.
Buying this machine: questions answered
How high can the Zoomlion ZS0808AC reach?
Working height is 10 m and the platform floor rises to 8 m. Working height is the platform height plus about 2 m for a person standing on the platform, which is how hire sizes are normally stated.
How wide is it, and will it fit through my doorway?
It is 0.81 m wide and 2.49 m long when stowed. We look for at least 50 mm of clearance beyond the machine width at each opening. Measure the narrowest point of the whole route, not just the final doorway: gates, door frames, corridors, lift cars and the turn in from a corridor, which needs more room than a straight approach.
What is its travel height?
Stowed (travel) height is 2.4 m. Check headroom along the route: door heads, roller doors, ducts, sprinklers and ramps.
How much weight can the platform carry?
Rated platform capacity is 230 kg. People, tools and materials all count. The extension deck has its own limit of 113 kg, which applies at the same time as the platform limit.
Can it reach over an obstacle?
A scissor lift goes straight up; the extension deck, where fitted, slides out over the front only. To work over an awning, a roof edge or plant, look at articulating boom lifts, which go up and out.
What surfaces can it be used on?
It is built for firm, level, hard surfaces: concrete floors, sealed paving and slabs. It is not for grass, gravel, mud or uneven ground. Check the floor or ground can carry its weight (see below).
Is it suitable indoors or outdoors?
It is rated for outdoor use. The maximum wind speed for this model is confirmed from its manual before outdoor work. Electric power means no exhaust indoors, but electric power alone does not make a machine rated for outdoor use.
Can it work on a slope?
Gradeability of 25% is the steepest slope it can drive up while stowed. That is not permission to raise the platform on a slope: elevated work needs ground within the manufacturer's tilt limit, and the tilt alarm stops elevation beyond it.
How is it charged?
It runs on batteries (Electric). Charger: Onboard (240V outlet). You need a standard power outlet near where it is parked, and it should be charged at the end of each day. Ask us if your site power is limited or temporary.
How long does a charge last?
Runtime depends on how far it drives, how often it lifts, the load, temperature and battery age, so there is no fixed number of hours. Plan to charge it every night, and tell us if your work involves a lot of driving between work areas.
How heavy is it, and can my floor take it?
It weighs about 2,090 kg. Weight alone does not show whether a floor can take it: suspended slabs, mezzanines, pits, pavers and lift cars need their rating checked against the wheel or track loads in the manufacturer's data, by someone able to assess the structure.
Do I need a licence to operate it in NSW?
No high risk work licence is needed for a scissor lift in NSW. Operators must still be trained and competent for this type of machine and familiarised with this model before use, and many sites ask for an industry card such as the EWPA Yellow Card plus their own induction. SafeWork NSW licence guidance.
Is this a specific machine, and what is included?
This listing is our fleet unit EH-0808. What is included (charger, manuals, keys) is listed on the quote.
What year is it, how many hours, and what condition?
Anything not shown here is confirmed in writing before purchase. Service history is available on request.
Is the figure shown a purchase price, and is GST included?
The price is given on application: ask for a current price for this machine. Freight is quoted separately.
Can I inspect it before buying?
Ask to arrange an inspection; the time and place are confirmed by the team.
Does it come with a warranty?
Any warranty is stated in writing on the quote. None is implied by this listing.
Can you deliver it to me?
Sale enquiries for listed machines are accepted Australia wide. Freight is quoted to your location, or you can collect it from our Western Sydney depot by arrangement.
What documents come with it?
The specification sheet is available now. The operator's manual and the handover inspection record are supplied at handover.
More in this category
Enquire about the Zoomlion ZS0808AC Narrow Electric Scissor Lift
Tell us where you are and what you need it for. An Equip Hire equipment expert will confirm the condition, the hours and what transport to your state would involve.
Looking to hire this machine instead? See hire details and delivery
