- 5.65 mWorking height
- 227 kgPlatform
- ElectricPower
Vertical Mast Lifts
12ft Electric Vertical Mast Lift
Skyjack SJ12
12ft vertical mast lift, 5.65m working height, 227kg, 0.77m wide and 782kg — one-person access through any doorway.
Indoor / hard standing
Haulotte Star 10 Vertical Mast Lift
Haulotte Star 10
26ft vertical mast lift with a 3m jib, 10m working height, 200kg — zero tail swing for work in confined areas.
Working height
10 m
Platform capacity
200 kg
Transport
Pickup: confirmation required
Platform height
8 m
Specification sheetDownload Specification sheet
Overview
About the Haulotte Star 10 Vertical Mast Lift
The Haulotte Star 10 is a vertical mast lift with a jib: 10m working height, 8m platform height and a 3m horizontal outreach from the vertical jib, which rotates through 130 degrees (+70 / -60). Zero tail swing means it can work hard against a wall or in a corner without the chassis swinging into anything. 200kg platform, 0.78 x 0.98m basket, 2,677kg, 25% gradeability to climb truck ramps, 24V brushless AC drive on non-marking tyres with a 250Ah traction battery and automatic centralised water filling.
Where it works
Best-fit jobs and sites
- Confined internal areas, plant rooms and corridors, work needing outreach as well as height without a full boom lift, over-and-around access in occupied buildings.
Good to confirm: 200kg platform. Some dimensions are published only as a diagram on the manufacturer sheet — confirm transport width and length against the machine before booking a truck. An online listing cannot replace a site assessment, so tell us the job and we will confirm suitability.
Decision panel
Will it suit this job?
Seven questions, answered from this machine’s verified specifications. 4 still to confirm with the hire team.
Reach
- Working height
- 10 mWhere your hands work with the operator standing on the platform. Size the machine on this figure.
- Platform height
- 8 mThe platform floor at full height, about 2 m below working height.
Access
- Machine width
- Confirm
- Stowed height
- Confirm
- Length
- Confirm
Surface
- Ground it suits
- Indoor / hard standingFirm, level ground: slab, sealed yard or compacted hardstand.
- Gradeability
- 25 %The steepest grade it may DRIVE on, stowed. Working on a slope is a separate, smaller limit in the manual.
- Levelling
- NoHow the machine is set level before it lifts.
Load
- Platform capacity
- 200 kg
Environment
- Power
- ElectricZero emissions and quiet: suits occupied buildings and after-hours work. Charges from a 10 A wall socket.
- Indoor / outdoor
- IndoorAs rated by the manufacturer. Wind ratings still apply outdoors.
- Tyres
- Non-marking solidNon-marking: safe on finished floors.
Transport
- Weight
- 2,677 kg
- Customer pickup
- ConfirmNot yet decided for this machine: Pickup has not been decided for this machine. Delivery is always available.
Compliance
- Competency
- Vertical mast lift under 11m — no high-risk work licence required in NSW; EWPA Yellow Card accepted competency.No high-risk work licence applies to scissor or vertical lifts in NSW at any height. Site inductions still apply.
- Documents
- Manufacturer spec sheet on fileThe sheet governs every figure above.
A Confirm mark means the decisive figure is not on this record. Send us the site details and we will answer it before quoting; we never guess a specification.
Specifications
Full specifications
Grouped for quick scanning. A row appears once its figure is verified for this machine; anything not listed here is not yet on the record, and the Fit & access panel above marks it Confirm. The manufacturer spec sheet always takes precedence.
Reach & platform2 specs
- Working height
- 10 m
- Platform height
- 8 m
Capacity1 spec
- Platform capacity
- 200 kg
Performance4 specs
- Gradeability
- 25 %
- Terrain type
- Indoor / hard standing
- Indoor use
- Yes
- Outdoor use
- Limited
Power & drive3 specs
- Power source
- Electric
- Battery
- 24V — 250Ah traction batteries, smart CAN charger
- Tyre type
- Non-marking solid
Machine & transport5 specs
- Manufacturer
- Haulotte
- Model
- Star 10
- Machine weight
- 2,677 kg
- Customer pickup
- Confirmation required, delivery always available
- Delivery
- Quoted by suburb & access
Transport
Getting it to site
Swipe
Delivered by us
Quoted by suburb, machine and access. We plan the truck, the unloading space and any overhead hazards before the run, tell us about docks, tight driveways and height limits when you book.
Customer pickup, confirmation required
Customer pickup has not been confirmed for this machine. Delivery is always available and is quoted together with the hire; if you would rather collect, ask the team and they will confirm whether a trailer combination is approved for it.
Logistics
Delivery, access and running
What we need from you, and what we take care of.
Swipe
Delivery
Quoted by suburb, site access and transport requirements, the machine and the delivery are quoted together for your dates.
Tightest access width
Tell us the narrowest gate, doorway or gap the machine must pass through and we will confirm the fit before it is loaded.
Licence and competency
Vertical mast lift under 11m — no high-risk work licence required in NSW; EWPA Yellow Card accepted competency.
Hire period
Hire runs from delivery or pickup until off-hire is confirmed. Rates are quoted for your dates, suburb and machine together, see our hire terms for responsibilities during the hire.
Not sure it will fit?
Send your suburb, your dates and the tightest access width. We will confirm the machine and quote the delivery with it.
Power
Charging this machine
Battery electric, charged from a normal household power point.
Swipe
Batteries
24V — 250Ah traction batteries, smart CAN charger
Maintenance-free batteries
Sealed and maintenance free: no topping up with water, no battery servicing to arrange during your hire.
Charges from a normal 10 amp wall plug
The charger is onboard. Plug it into any standard 10 A / 240 V power point, no three-phase, no site power upgrade and no separate charger to hire.
Overnight charge, full day’s work
About 8 hours from flat. Runtime on the day depends on battery condition, drive distance and lift cycles, so tell us if the job runs long shifts.
Keeping it charged on site
- Confirm a live, accessible power point near where the machine parks overnight. A machine left away from power starts tomorrow flat.
- Plug in at the end of every shift, not “when it gets low”. Topping up at breaks helps on heavy days.
- Charge in a ventilated area and keep the charger and lead dry.
- Zero emissions and quiet running, so it suits indoor, occupied and after-hours work.
Safety
Pre-start checks, every day
Every Equip Hire machine is function-tested before it leaves the yard. The operator still checks it before each shift, tick these off as you go.
Swipe
1
Walk around
0/4
2
Power on
0/3
3
Function test
0/3Found a fault?
Tag it out and call us on 0472 721 234. Never operate a machine with a known fault, we will repair or swap it.
What counts as the record
Ticking here is a memory aid on your phone, nothing is stored. The machine’s own logbook and pre-start check sheet are the record. Based on the manufacturer’s daily check requirements and SafeWork NSW guidance for this kind of equipment.
Site prep
Before it arrives
Five minutes of checking here is what keeps a delivery from becoming a return trip.
Swipe
1
Measure the route, not the door
Every gate, corridor and lift on the way to the work area. Handles, hinges, bollards and stored materials all eat clearance.
2
Confirm the floor
A ground-bearing slab is fine. Suspended slabs, mezzanines and raised floors need the wheel loads checked against the floor rating.
3
Clear the work zone
Overhead services, sprinkler heads and light fittings at working height, and an exclusion zone for people below.
4
Make delivery space
Room for the truck to stop and unload safely. Tell us about docks, driveways and height limits when you book.
5
Find the power point
A live outlet near overnight parking so every day starts on a full charge.
Avoid
Mistakes we see weekly
The things that most often send a machine back or hold up a job.
Swipe
Booking on ceiling height
Measure to the actual task height, then choose the machine. Nothing added “just in case”.
Using the nominal door size
An 820 mm door leaf is not 820 mm of clear opening once the stop and hardware are counted. Measure the gap.
Assuming it can cross a bit of lawn
Wheeled machines rut turf and bog in soft ground. Say so when you book and we will send a tracked machine.
Leaving inductions to delivery morning
Shopping centres and managed sites need the paperwork approved before the truck arrives.
Documents
You might also consider
- 6.75 mWorking height
- 227 kgPlatform
- ElectricPower
Vertical Mast Lifts
16ft Electric Vertical Mast Lift
Skyjack SJ16
16ft vertical mast lift, 6.75m working height, 227kg, 0.77m wide — the taller mast lift, still through a standard doorway.
- 10 mWorking height
- 200 kgPlatform
- ElectricPower
Vertical Mast Lifts
33ft Electric Vertical Mast Lift
LGMG M0810JE
33ft vertical mast lift with a jib — 10m working height, 3.2m horizontal outreach, zero tail swing and a 1m wide chassis for indoor up-and-over work.
More in this category
Planning guides
Get a quote for the Haulotte Star 10 Vertical Mast Lift
Tell us the job, the dates and the suburb. We will quote the machine and delivery together.